Installing a Rigid SR-Q Backup Light Kit

SHARE IT!

SRQ-thumb

 

This new lighting kit includes everything you need to install a pair of Rigid Industries back-up lights on your vehicle: Two LED lights, and extended 25′ wiring harness hardware and black covers. This kit features our patented Hybrid optics system combined with a Diffused lens, to offer a powerful 60deg beam pattern for unmatched visibility.

 

 

Features: 

  • Patented Hybrid Optics
  • 60° Diffused Pattern
  • Extended Wire Harness
  • 50,000+ Hr LED Lifespan
  • Instant On / Off – No Warm Up
  • RoHS Compliant
  • Over / Under Voltage Protection
  • Cast Aluminum Housing
  • Durable Polycarbonate Lens
  • Integrated Thermal Managament
  • GORE® Pressure Equalizing Vent

Designed, Engineered, &
Assembled in the USA

RI98003B

Kit Includes:

2- Rigid Industries SR-Q/SR-Q FM LED Lights

1- Custom Back-up Kit Wiring Harness

2 – Stainless Steel (18-8) ¼” x 1.5” Socket Head Cap Screws

2- Stainless Steel (18-8) Lock Washers

2- Stainless Steel (18-8) Mounting Brackets

2 – Stainless Steel (18-8) Carriage Bolts

2- Stainless Steel (18-8) 1/4” Nylon Insert Lock Nuts

2- Stainless Steel (18-8) Standard Nuts

 

large_14990_raptor_back-up_light_kit+sr-q-2Tools Needed:

Sharpie

Painters Tape

Power Drill

¼” Drill Bit

¾” Drill Bit

¼” Wrench   Plasma Cutter, Dremel, or Air Saw

3/16” Hex Wrench   Metal Grinder or Metal File

 

 

To find out more about this product visit: Rigid Industries Back Up Light Kits

Check out Rigid Industries Install Video below with helpful information and tips as well as step-by-step instructions for installing the Rigid SR-Q Backup Light Kit.

Important – Rigid Industries highly recommends using a certified professional to install and wire your lights.

Remember – Only install lights on a flat surface. Always disconnect your battery before working with fuses or your electrical system.

Step # 1 – Choose a location for your Rigid Industries Backup Light and begin masking off the nearby areas with Painters Tape.

Step # 2 – Cut off the supplied Mounting Template and attach it to your vehicle. Use a sharpie to trace the cut out area in the inner part of the Mounting Template.

Step #3 – Using a Power Drill, drill 2 (two) quarter inch holes on both sides of the mounting templates. After both mounting holes are drilled remove the mounting template and drill another quarter inch pilot hole anywhere inside the marked off area.

Step #4 – Plasma Cutter, Dremel, Air Saw or cutting torch to remove the marked metal. Use a Grinder or File to smooth the edges of the cut out area.

Step # 5 – Slide your Rigid SR-Q Backup Light into place and use the screws and nuts provided to secure your light. Remove the safety tape and repeat the steps for the second Rigid SR-Q Backup Light.

Comments

comments

Leave a Reply