Installing a Ford Raptor SVT LED Grille

SHARE IT!

The Rigid Industries Raptor SVT LED Grille is designed to fit the curvature of the Ford Raptor SVT front face while providing high output lighting with a Rigid 30″ RDS-Series curved light bar. There is no medication of your existing grille shell, this product is a straight replacement of your grille. This video shows the step by step install of this LED Grille and Tim Wimmer shows us the tips to make sure you do it right.

Features:

  • 100% stainless steel
  • Custom laser-cut mesh pattern
  • Two-piece construction, bolted together, not welded
  • UV Resistant, Abrasion Resistant, Polyester Based Powder-Coat

Designed, Engineered, & Assembled in the USA

Tools:

T25 Torx Wrench
Universal Wrench Set

 Kit Includes:

(4) 1/4″-20×3/4″ Socket Button Cap Screws
(2) 1/4″-20×3/8″ Socket Button Cap Screws
(2) M6x1MM 18-8 Hex Flange Locknuts
(2) M6 – 1.0x16MM Socket Button Cap Screws
(6) 1/4″ Nylon Insert Lock Nut
(2) 5/16″ 18 Nylon Insert Lock Nuts
(4) 1/4″ SS Flat Washers

To find out more about this product visit: Rigid Industries 2010-2014 Ford Raptor SVT LED Grille Install 

Check out Rigid Industries Install Video below with helpful information and tips as well as step-by-step instructions for installing the 2010-2014 Ford Raptor SVT LED Grille Install
Important – It is strongly recommended that this product be installed by a professional.

This product may have more surface area than your factory grille. It may reduce airflow. Reduction in airflow can potentially lead to overheating or other mechanical issues.

This product has been pre-bent to fit the contour of your vehicle grille shell. However, it may have partially flattened during shipping. It may be necessary for you to re-bend in order to get a proper fit.

Remember – Always disconnect battery before servicing any fuses or electrical systems.

Step #1- Remove the factory grille from the 2010-2014 Ford Raptor SVT LED grille.

Step #2-  Remove the wire harness from the factory grille. Unplug the factory wire harness with a T25 Torx Wrench, 8MM for the top of the marker lights, and a flat blade or possibly a panel popper to remove the harness off of the plastic shell.

Step #3- Use the removed back plate by sliding the plate through the light in the front of the grille and reattach the bolt. 

Step #4- Install the rubber bumper stoppers on each side of the lower corners of the Raptor LED Grille by using the M6 screws.

Step #5- Tape the hood of the 2010-2014 Ford Raptor so there will be no scratches while installing the LED Grille.

Step #6- Install the Rigid Industries RDS-LED light bar into the the 2010-2014 Ford Raptor SVT.

 

Comments

comments

Leave a Reply