Rigid Industries A-Series Boat Deck Light Kit Install

SHARE IT!

Image 1

 

The elite Brandon Palaniuk Signature Series Boat Deck Light Kit from Rigid Industries is a must have for every angler. Whether you’re trimming a jig the morning of a tournament or re-spooling the night before a weekend of fishing, this kit will provide you with the light needed to get the job done. The Brandon Palaniuk Boat Deck Light Kit is offered in a variety of colors and includes all wiring, mounting hardware, and instructions for a clean and easy install.

Image 3

Features:
  • Die-Cast Aluminum A-Series Housing
  • Polycarbonate Lens
  • Stainless Steel Hardware
  • Voltage Range: 10-28 Vdc
  • Operating Temp: -40°F to 140°F
  • Vibration Test Rating: MIL-STD-810G
  • Water/Dust Ingress Rating: IP69K
Specifications:
  • Watts: 12
  • Amp Draw: 0.8
  • LED’s: 12
  • Raw Lumens: 800
  • Voltage: 10-28V

Image 4

 

Kit Includes:

  • (4)* or (6)* A-Series lights with 15′ Leads
  • Distribution Block(s)* for Easy Wiring
  • 27′ Wiring Harness with Fuse & Switch (pendant switch or rocker switch)
  • Mounting hardware
  • 3 Amp Blade Fuses (4 or 6)
  • 1 or 2 Switches (1 or 2 Colors)

Step #1 – It is recommended that more than one person performs the install. An extra hand makes it easier to install the product and helps the process flow smoother.

Remember – Be careful not to cut into any rod strap, buckles or wires.

*Use a tap measure to evenly space out the LED lights.*

Step #2 – Take the rubber gasket off the A-Series LED light and place the gasket in the desired location. Once the desired location is set, then drill holes into the side of the boat where the gasket will be placed.

*There might be foam inside the side of the boat. There should be no problem working around the foam.*

Step #3 – Use a screwdriver to tighten the lights so you don’t strip the fiberglass.

Helpful hint(s)– The crew at Get A Limit Outdoors ran all the lights to a bus terminal. The power came from an accessories switch that was running the factory lights.

The day boxes which had the factory LED Lights were removed and replaced with Rigid Industries A-Series LED lights.

Step #4 – Use your bus terminal (included in the kit) to turn on your A-Series deck.

Check out the Rigid Industries LED Lighting A-Series Boat Deck Light Kit Install below.

Comments

comments

Leave a Reply